Wood grips for Bersa / Firestorm double stack pistols.
Installing grips using a set of Walnut-made HC9 grips.


Simply roll your mouse cursor over thumbnails in the thumbnail grid,
and some more information will be displayed.
Click thumbnail to enlarge image.

Make sure the pistol is unloaded.

You received your grips for your HC9 pistol. They came with a washer pressed into the left hand side grip (in this example) and a bolt.



Check if they fit the frame properly. Do it side by side.
Do NOT force the grips while installing!
All grips were mounted on a frame and the fit was excellent. They do NOT need additional modification.
Using more force than required or using wrong mounting technique will lead to crack!



To remove the existing grip please see manual or ask trained person.

Mounting starts. Make sure the pistol is unloaded!
1. Align the tang of the grip to the frame.


2. Push/rotate the grip half into place.
Push it to the front and a little upward. It needs bit of pressure.


3. Check if the grip contacts the frame properly.
A hairline gap between the frame and grip is acceptable.


The same goes for the other side.
4. Align the tang of the grip to the frame.


5. Push/rotate the grip half into place.
Push it to the front and a little upward. It needs bit of pressure.


6. Check if the grip contacts the frame properly.
A hairline gap between the frame and grip is acceptable.


7. If both sides are looking good then mount both grips on the pistol.


8. The bottom of the grips are flushed with the frame.


9. The front edge must follow the frame.


10. Through the hole at the bottom of the grips, push and rotate the grip catch into its lower (grip locked) position. Hold the grips tight with your hand while doing this, and...


11. ...install the bolt to keep the two grip halves together.
Do NOT overtight the screw otherwise you will have the nut torn out of the grip!
Use screwfix adhesive to avoid overtightening!


12. Done. Your new grips are on the frame. Please check functionality before using the pistol.
Having problems with installing grips? Please contact us.